There were/are about 2 dozen versions of that G60 Johnson valve and if you read the fine print in a S86 or WR universal board the final responsibility for safety and liability rests on the guy who did the conversion not them ( applies to flame failure timing etc etc which you cannot get from Johnsons on those valves). ![]() I hate/HATED to see S86 controls hanging in the air and hackers converting these units as the next guy to work on it was me and not the hacker. I converted a few G8E conservators ( predecessor to his ) and some G16s like his and it runs around $1500 or more. ![]() Lennox has a conversion kit which gives you a new center burner and pilot burner from a G20 as well as a 3 wire gas valve and a S86 control and wiring harnesses etc.
0 Comments
Leave a Reply. |